AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Ipad control resolume arena 53/9/2024 Most effects also have additional parameters that you can control. You will see that there are two sliders under the Bendoscope effect.Īll video effects have the Opacity slider - it is used to mix the effected video with the original. Now, look back to the place where you dropped the effect. You should immediately see that the output video has been distorted by the effect. You'll know when you're in the right place when you see four colored corners appear around the Composition tab. As you get over there, drop the effect in the area where it says 'Drop effect or mask here'. Now drag it over to the left where there is a tab called Composition. Any effect will do, but I recommend Bendoscope as a good one to start with. These are the video effects that are included with Resolume. Select the Effects tab.īelow the tab will now be a list of effects. Over on the right hand side of the interface are some tabs that say 'Files', 'Compositions', 'Effects' and 'Sources'. You can also use the 'M' (master) slider to control both at the same time. Logically enough, the 'A' slider fades the audio of the layer in and out. Try sliding these up and down on the layers that you have playing. There are two vertical sliders marked 'A' and 'V'. Have a look over to the left of the thumbnails. This time, the old clip will continue playing and the new clip will be mixed with it. Now try clicking a clip from a different layer. You will see that, at the start of the next bar, the output will change to play the new clip. Try clicking another thumbnail on the same layer as the one that is already playing. Playing one clip is all very well but mixing clips together is where the fun really starts.Įach of the horizontal rows of clips is a separate layer. You can resynchronise it by clicking the clip thumbnail again - it will start again at the start of the next bar. Note that messing with the clip like this will mean that it is no longer synchronised with the BPM - the tempo will be right but it will be out of phase. You can also grab the moving blue wedge directly to scratch the clip - wikka wikka wah! You can use the Forwards, Backwards and Pause icons to start and stop the clip. The Transport section of this tab is the bit we are interested in for now. You can take control of the clip that is playing by clicking the Clip tab. You should now see the clip playing in the output window on the left and hear the audio of the clip. Don't worry, if you want to launch clips instantly, you can set them up to do that.īut first things first. Note that these clips are set up to be synchronised to the BPM (Beats Per Minute) setting, so the clip may not start playing instantly - it will wait for the start of the next bar. Go ahead and click one of the thumbnails now. Trigger Clipsīelow the menu bar, you should see a set of horizontal rows that each have some controls on the left and a set of thumbnails. A composition is what we call a complete Resolume setup - each composition can include sets of clips, preprogrammed effects and all other settings that you need for a performance. It may look complicated at first but don't worry - it will soon all make sense.Ī new Resolume install comes with an example composition. Right! You've got Resolume installed so let's jump in and see what it can do, shall we?
0 Comments
Read More
Leave a Reply. |